<ins id="nqn6d"></ins>
<ins id="nqn6d"><form id="nqn6d"></form></ins>
<xmp id="nqn6d"><ins id="nqn6d"><xmp id="nqn6d">
<ins id="nqn6d"></ins>
<ins id="nqn6d"><form id="nqn6d"><xmp id="nqn6d">
<xmp id="nqn6d"><form id="nqn6d"></form><ins id="nqn6d"></ins>
<ins id="nqn6d"></ins>
<form id="nqn6d"></form>
<xmp id="nqn6d"><form id="nqn6d"><button id="nqn6d"></button></form>
<ins id="nqn6d"></ins><ins id="nqn6d"></ins><form id="nqn6d"><button id="nqn6d"><button id="nqn6d"></button></button></form>
<xmp id="nqn6d"><form id="nqn6d"><form id="nqn6d"></form></form><ins id="nqn6d"><xmp id="nqn6d"><form id="nqn6d"></form><xmp id="nqn6d">
<xmp id="nqn6d"><form id="nqn6d"></form>
<xmp id="nqn6d"><ins id="nqn6d"><form id="nqn6d"><xmp id="nqn6d">
<form id="nqn6d"><form id="nqn6d"><button id="nqn6d"></button></form></form><xmp id="nqn6d"><form id="nqn6d"></form>
<xmp id="nqn6d"><xmp id="nqn6d"><xmp id="nqn6d"><form id="nqn6d"></form>

全國咨詢電話:0769-85910022
美中鞋業網會員產品展示  JW-101水性刷膠機(容量五公升)




JW101水性膠輸送機(容量五公升)

JW101Water based giue converyer(capacity 5 litre)

尺寸(L×W×hcm

凈重

毛重

氣壓

32.5×32.5×58

15KG

17.50KG

5KG/c


本機熱點:

一. 本機適用于刷水性膠

二. 采用不銹鋼材質避免腐蝕,配備膠量可視管準備控制加膠時間。無內桶裝置,膠水可全部用完不剩。

三. 密封式設計,可有效防止防水:

1表層凝固,濃度變高。

2. 涂布性不佳,膠太厚造成浪費。

3. 黏度升高,膠水變質,影響拉力。

四.可能約8%水性膠用量,有效改善工作環境之空氣質量,維護工作人員健康。

五.不需經粘膠過程,可提高8%以上之工作效率,在操作中有充分的自我檢視時間。 

注意事項:

一.打開機蓋前一定要先泄壓。

二.供氧之氧管內不可有水氧存在,以免造成壓力桶內膠水變質,氧氣必須維持在4kgc左右。

三.下班時應將出膠口關門及進氣口關門開關

四.保持壓力桶管道清潔,停止使用48小時以上時,應先將機器清洗干凈,連續使用一個月時,應將機器清洗干凈一次,以免造成管道堵塞。

Features:

一.This machine is suitable for brushing water-based adhesive

二. Stainless steel material shall be used to avoid corrosion, and visual tube for glue quantity shall be equipped to control glue adding time. No inner barrel device, glue can be used up.

三 sealed design can effectively prevent water-proof:

1. The surface solidifies and the concentration becomes higher.

2. Poor coating performance, too thick glue causing waste.

3. The viscosity increases and the glue deteriorates, affecting the tensile force.

3. About 8% of the water-based glue may be used to effectively improve the air quality of the working environment and maintain the health of the staff.

.It can improve the working efficiency by more than 8% without glue process, and has sufficient self inspection time in operation.


 Notices:

I. make sure to release the pressure before opening the cover.

2. There shall be no water or oxygen in the oxygen supply pipe, so as to avoid the deterioration of the glue in the pressure barrel. The oxygen must be maintained at about 4kgc .

3. close the rubber outlet and air inlet at the time of off duty

4. keep the pipeline of pressure barrel clean. When it is not used for more than 48 hours, clean the machine first. When it is used continuously for one month, clean the machine once to avoid blocking the pipeline.



2017/5/6 10:52:23 2023-02-18 中國